Use the CNET command without an argument to check the Cresnet ID of a Slave processor.If performed successfully the processor prompt will change.Example: Changing a PRO2 to Cresnet ID 12.At the prompt enter, CNET to set the Cresnet ID.Connect to the 2-Series processor that you want to make a Cresnet Slave.Open Toolbox Text Console (or Viewport).Note: To avoid getting a non critical error message logged, comment out in SimplWindows the Front Panel definition of a Slave processor if applicable.įirst, the 2-series processor must be assigned a Cresnet ID. Configure the IP address to be the address of the slave processor. For Ethernet, expand the C2ENET-x slot in the Tree View of the Master processor, Drag/ Drop the Ethernet Remote processor at the desired IP ID or right mouse click on an open IP ID and select.For Cresnet, expand the C2NET-device slot in the Tree View of the Master processor, Drag/ Drop the Remote processor at the desired Net ID or right mouse click on an open Net ID and select.Right Click on the Remote Processor to add, select.Drag/ Drop the Remote Processor to add onto the Blue Cresnet Units arrow or the Red Ethernet Units arrow found under the Master Control processor.The Remote Processors available for Ethernet control are located in the folder found under the, which is found under the main folder.The Remote Processors available for Cresnet control are located in the folder found under the.Click, drag and drop the desired processor to either the Ethernet or Cresnet slot on the Master Controlling processor.Within the tab are the available remote processors.Note: To show the Library select,, from the top pull down menu Select the folder from the Auxiliary Devices Libray. Open the program in view, select the icon.Note: For Master processor, ensure they are running the following Firmware: Refer to the " 2-Series Control Systems Reference Guide" sections on Master-Slave Modes and Operation. (This method can also be implemented with XGen and even an ST-CP or CNMS II processors.) For example, a control processor running the AV system / Theater can send and receive signals to the Lighting Control processor running the whole house lights when the room needs to have its lights adjusted. With this method each processor runs its own program and passes only the needed signals (digital, analog, serial) back and forth between the 2 (or more) processors. Note: Refer to OLH 5109 for details regarding slaving 3-series processors.Īn alternative to slaving, Intersystem Communication can be done over Ethernet ("EISC") or RS232. Note: This feature is available on 2-Series or 3-Series & requires SIMPL v2.04.13+ / CresDB v16.0.0+. A slave processor can be connected/controlled by its master via Cresnet or Ethernet. The "Controlling" ("Master") processor can utilize a Slave's available features (RS232 ports, IR ports, etc.), but not its processing power. When configured as a slave, the remote processor does not run its OS or a SIMPL program. 2-Series processors can be configured to operate in "2-Series Remote Processor" ("Slave") mode.
0 Comments
Leave a Reply. |